In the past, faucets were not a primary focus of water efficiency advocates, given the 1992 Energy Policy Act (EPAct) and subsequent U.S. Environmental Protection Agency (EPA) actions limited faucet flows to 8.3 L/minute (2.2 gallons per minute [gpm]) at 414 kPA (60 psi).
+ Read More
|
It is tempting to whittle commercial faucet choices down to two types: sensor and manual. However, there is more to consider. For ‘green’ buildings, while it seems obvious to find faucets that use less water, this oversimplifies the issue.
+ Read More
|
Exterior soffits perform essential functions for ventilating, shading, and directing water away from a building. Regardless of geography or climate, exterior soffits are subjected to positive and negative wind loads.
+ Read More
|
For many years, designers and contractors have espoused tilt-up construction for providing a more airtight building envelope than competing wall assemblies, such as wood and metal stud wall, metal siding, and concrete and brick masonry. Now, code language may also be a supporting factor.
+ Read More
|
Observations of numerous building envelope failures in stucco (i.e. portland cement plaster) indicate it may lack durability when correct installation practices are not performed. One of the most common problems is cracked stucco and with the trend of using the material as a cladding, the situation will get worse.
+ Read More
|
As the most viewable buildings of their era still standing, the California Missions are not only state history made corporeal, but also one of the major reasons stucco is so common in the Southwest.
+ Read More
|
All over the United States, a hard truth is being uncovered—underneath carpet and vinyl tile in buildings everywhere, there lurks ugly concrete. With acceptance of exposed concrete floors on the rise, and remodeling continuing to dominate the construction market, plans to polish existing concrete subfloors are numerous.
+ Read More
|
Federal, state, and local specifiers continually seek affordable, durable, and aesthetically pleasing wall solutions to border bustling highways and adjacent neighborhoods. The principal purpose of these is typically to provide citizens with a visual barrier to the highway and sometimes to mitigate traffic noise.
+ Read More
|
Designers of commercial and institutional buildings in urban settings often work on constrained sites where the service areas exposed to weather or wash-down are located over occupied spaces below.
+ Read More
|
Failures of claddings like adhered masonry veneer–also known as manufactured stone–often stem from poor flashings, misapplied air and water-resistive barriers (WRBs), and limited drainage. Resulting problems related to moisture intrusion into the wall assembly’s dry zone are moist wall interiors, wet insulation, and rot in sheathing and framing.
+ Read More
|
|
|